TM 5-5420-234-14&P
4-12. UNIT TROUBLESHOOTING (continued).
3.
ENGINE HIGH IDLE DOES NOT OPERATE (continued).
CONTINUITY TEST
CAUTION
Electrical power must be shut off
from circuit before continuity can
be checked. Failure to comply with
this caution may result in damage
to test equipment or electrical sys-
tem.
(1) Disconnect remote control cable from
components.
P9
(2) Set multimeter to ohms position.
NOTE
A reading of infinity indicates an
open circuit.
(3) Connect multimeter to leads at each
end of wire, and check multimeter for
continuity. Check for continuity
between position "A" on chassis end
and position "M" on remote control
P8
end. Also check for continuity
REMOTE CONTROL CABLE
between position "B" on chassis end
and position "B" on remote end.
4-67
