MWO 9-2320-279-20-8
d. Modify hose tenna support.
with washer (12), lockwasher (11) and nut
(1) Remove nut (1) and screw (2) from clamp
(10).
(3) on hose tenna support (4).
NOTE
(2) Remove glad hands (5) from hose tenna
support (4).
Spring loop should be facing rear of vehicle
prior to marking.
(3) Remove two nuts (6), washers (7), and
screws (8) from glad hand retainer bracket
(8) Mark center of loop. Rotate spring (19)
(9) on hose tenna support (4).
and drill .34 inch diameter hole for spring
hold down.
(4) Remove nut (10), lockwasher (11), and
washer (12) securing hose tenna support
(9) Secure spring (19) on bracket (13) with
(4) to bracket (13) and remove hose tenna
screw (18), flat washer (16), lockwasher
support (4).
(15) and locknut (14).
(5) Cut hose (17) to 6 1/2 inches and install
(10) Install glad hand retainer bracket (9) to
onto hose tenna support (4).
hose tenna support (4) and secure with
two nuts (6), washers (7), and screws (8).
(6) Install spring (19) over hose tenna support
(4).
(11) Install clamp (3) onto hose tenna support
(4) and secure with nut (1) and screw (2).
(7) Install hose tenna support (4) with spring
(1 9), on bracket (13) and secure
(12) Attach qlad hands (5) to hose tenna
support t4).
8
