MWO 9-2320-279-20-8
c. Install six slave cable support hooks.
(2) Install nut (8) and flat washer (9) on hook
(7). Insert hook (7) in drilled hole (1) and
NOTE
secure with flat washer (9), lockwasher
(10) and nut (8). The loop of the hook (7)
It may be necessary to remove expanded metal
should be facing to the side and rear of the
vehicle (approximately 450 angle) to allow
installation and removal of the slave cable.
(1) Drill two .34 inch diameter holes (1) and
(2) as indicated.
(3) Insert hook (7) through underside of drilled
hole (2). Make sure loop of hook is facing
NOTE
inward.
All hooks will be assembled and installed
NOTE
basically the same way. The position of the
hooks may vary.
If hooks are too large for existing holes in tool
stowage box, ream out holes to .34 inch
diameter.
(4) Install nut (8) and flat washer (9) on two
hooks (7). Insert hooks (7) in existing
holes (3) and (4) located in bottom of tool
stowage box. Secure hooks (7) with flat
washer (9), lockwasher (10) and nut (8).
The loop of the hooks (7) should be facing
inward.
(5) Drill two .34 inch diameter holes (5) and
(6) as indicated.
(6) Install nut (8) and flat washer (9) on two
hooks (7). Insert hooks (7) in drilled holes
(5) and (6) and secure with flat washer (9),
TYPICAL HOOK AND
lockwasher (10) and nut (8). The loop of
MOUNTING HARDWARE
the hooks (7) should be facing up.
6