TM 9-2320-279-34-2
Brake System Maintenance Instructions (Cont)
NOTE
Make sure bent tang on thrust washer fits in slot of end cover.
(3) Install preformed packing (5) and thrust washer (6) on end cover (4).
(4) Place crankcase (2) on end.
(5) Install thrust washer (7) in crankcase (2) with bent tang in slot in crankcase.
(6) Install crankshaft (8) in crankcase (2).
(7) Install end cover (4) with four lockwashers (9), and screws ( 10). Tighten screws to 15 to 20 lb-ft
(20 to 27 Nm).
(8) Install two unloader valve seats (11) and two bushings (12) in cylinder block (13).
(9) Install four plugs (14).
(10) Install plug (15).
(11) Place crankcase (2) on base and install key (16), drive plate (17), and nut (18). Tighten nut to
120 lb-ft (163 Nm).
11-25