TM 9-2320-279-34-2
(23)
(24)
(25)
(26)
(27)
(28)
Brake System Maintenance Instructions (Cont)
Lubricate piston (31), rings (34 and 35), and bearing
inserts (36) with lubricating oil.
Place crankcase (2) and cylinder block (13) on its
side.
Turn crankshaft (8) so one connecting rod journal is
down.
Insert connecting rod (30) with piston (31) through
cylinder block (13) until connecting rod is seated on
crankshaft journal.
Install two bearing inserts (36), bearing cap (37), and
two screws (38). Tighten screws evenly to 125 to
140 lb-in (14 to 16 Nm).
Repeat steps (24) through (28) to install second
connecting rod.
NOTE
Be sure to install screw and cover in proper position.
(29) Install gasket (39), cover (40), five lockwashers (41),
screws (42), and one screw (43).
(30) Install two inlet valve guides (44) and inlet valves (45).
(31) Install two springs (46).
11-27