TM 9-2320-279-34-3
Power Takeoff (PTO) and Hydraulic Pump Maintenance Instructions (Cont)
19-4.
HYDRAULIC PUMP REPAIR (M984E1) (CONT).
(13)
Place inlet port section (2) in vise with
inside facing up.
NOTE
Model B has preformed packing. Do
step (13.1) for Model B.
(13.1) Install preformed packing (21.2) on inlet
port section (2).
(14)
Install seal gland (22) in inlet port
section (2).
(15)
Install seal retainer (23) with flat side
facing up.
(16)
Install rear wear plate (24) with bronze
side up on inlet port section (2).
(17)
Aline notches and install center
section (25).
CAUTION
Make sure gear teeth on drive gear and driven
gear are same size or equipment can be
damaged when installing end cover.
NOTE
Grooved end of gears goes in inlet port section.
(18)
Install driven gear (26) and drive
gear (27) in inlet port section (2).
19-24 Change 3
