TM 9-2320-279-34-2
Brake System Maintenance Instructions (Cont)
(9)
Soldier A installs and holds two clamps (5) while Soldier B installs two screws (6) and nuts (7).
NOTE
Tighten nut on Model B clamps to 25 lb ft. (34 N•m).
(10)
Rap clamps (5) with hammer and tighten two nuts (7) to 40 lb-ft (54 N•m). Release holding
device.
NOTE
Install yoke until threads of stud just come through yoke.
(11)
Install jamnut (8) and yoke (9). Tighten jamnut against yoke.
d. Follow-on Maintenance. None.
END OF TASK
11-5. BRAKE RELAY VALVE REPAIR.
This task covers:
a. Disassembly
b. Cleaning/Inspection
INITIAL SETUP
M o d e l s
All
Test Equipment
None
c. Assembly
d. Follow-on Maintenance
References
None
Equipment Condition
TM or Para
Condition Description
Brake relay valve on
work surface.
Special Tools
None
S u p p l i e s
Grease, lithium base, Item 35, Appendix C
Solvent, drycleaning, Item 57, Appendix C
Personnel Required
MOS 63W, Wheel vehicle repairer
Special Environmental Conditions
None
General Safety instructions
None
Level of Maintenance
Direct Support
Change 2
11-9
