TM 9-2320-279-34-1
Axles No. 1 and No. 2 Maintenance Instructions (Cont)
9-2. AXLE SHAFT ASSEMBLY REMOVAL/REPAlR/lNSTALLATlON (CONT).
(2)
(3)
(4)
(5)
Remove eight screws (2)
from cage ring halves (1).
Remove cage ring halves (1)
from shafts (3 and 4).
Assemble cage ring
halves (1) with eight
screws (2). Tighten screws
to 30 lb-ft (41 Nm).
Measure inside diameter of
cage ring halves (1) and
outside diameter of yokes
on shafts (3 and 4). If
difference is more than
0.200 in. (5.08 mm), replace
cage ring halves (1) and
shafts (3 and 4).
Remove eight screws (2)
from cage ring halves (1).
c. Cleaning/Inspection.
(6)
(1)
(2)
(3)
W A R N I NG
Adhesives, solvents, and sealing compounds can bum easily, can give off harmful
vapors, and are harmful to skin and clothing. To avoid injury or death, keep away
from open fire and use in well-ventilated area. If adhesive, solvent, or sealing
compound gets on skin or clothing, wash immediately with soap and water.
Clean parts in dry cleaning solvent.
Inspect parts for damage.
Replace damaged parts.
d. Assembly.
(1)
(2)
(3)
(4)
(5)
Apply light film of grease to
four trunnions (1) and two
halves of cage ring (2).
Aline matchmarks and
install two halves of cage
ring (2) on two shafts (3
and 4).
Install eight screws (5). Do
not tighten.
Move two shafts (3 and 4)
to check for free
side-to-side movement
inside cage ring (2).
Tighten eight screws (5) to
95 lb-ft (129 Nm).
9-4
