TM 9-2320-279-34-1
Transfer Case Maintenance Instructions (Cont)
8-4. TRANSFER CASE REPAIR (CONT).
a.
Assembly.
WARNING
Adhesives, solvents, and sealing compounds can burn
easily, can give off harmful vapors, and are harmful to
skin and clothing. To avoid injury or death, keep away
from open fire and use in well-ventilated area. If
adhesive, solvent, or sealing compound gets on skin or
clothing, wash immediately with soap and water.
(1)
Apply light bead of adhesive to inside flange
of end cap (1). Apply sealing compound to
threads of six screws (2). Install six
screws (2), lockwashers (3), and end cap in
transfer case front half (4).
(2)
Support transfer case front and rear halves (4 and 5), open side up, on clean work surface.
NOTE
Use hammer and brass drift to seat taper bearing cups against shoulders.
(3)
Install three bearing cups (6) in transfer case rear half (5) and two bearing cups in transfer case
front half (4).
(4)
Install bearing cup (7) in bearing support (8).
8-18 Change 3
