TM 9-2320-279-34-1
Transmission Maintenance Instructions (Cont)
a.
Removal.
(1)
Remove retaining ring (1).
(2) Remove backplate (2).
(3)
Remove four friction plates (3) and four
steel plates (4).
NOTE
Some clutch assemblies contain paper friction
plates. Discard all paper friction plates.
They are replaced by graphite friction plates.
(4) Remove support housing
anchor screw (5) and
washer (6).
(5)
Remove retaining ring (7)
holding center support
housing (8).
NOTE
Center support housing is fitted to
transmission housing with very little
clearance and may bind if
transmission housing is cold. Heat
transmission housing with heat
lamp or warm current of air.
If support housing starts upward
and then binds, tap center support
housing downward and lift again.
(6)
Lifting straight up, remove center
support housing (8) and thrust
washer (9) from transmission
housing (10).
Change 3
7-123