TM 9-2320-279-34-1
(20)
(21)
(22)
(23)
Transmission Maintenance Instructions (Cont)
Find gap in retaining ring (21).
Install shim stock between retaining
ring (21) and teeth of PTO gear (22).
Push retaining ring in forward clutch
assembly (4). Put shim stock every 3 in.
(76 mm) around forward clutch
assembly.
Press forward clutch assembly (4) out
of PTO gear (22).
Remove PTO gear (22), forward clutch
assembly (4), PTO gear removal tool,
and PTO gear removal fixture from
press.
c.
Cleaning/Inspection.
WARNING
Adhesives, solvents, and sealing compounds can burn
easily, can give off harmful vapors, and are harmful to
skin and clothing. lb avoid injury or death, keep away
from open fire and use in well-ventilated area. If
adhesive, solvent, or sealing compound gets on skin or
clothing, wash immediately with soap and water.
(1)
Clean all metal parts with drycleaning solvent and
inspect for damage. Replace damaged parts.
(2)
Turbine shaft is pressed in forward clutch housing
and should be tight. Replace forward clutch
housing if there is any up and down movement.
(3)
Replace all 20 piston release springs if any three springs do not meet the following load-height
requirements:
(a)
Length without load: 1.25 in. (31.8 mm)
(b)
Length under load: 0.88 in. (22.4 mm) with load of 17.9 to 18.9 lb (79.6 to 84.1 N).
(4)
Clean ball pockets (1) with drycleaning solvent if there is leakage at bottom side of housing or if
balls do not move freely of their own weight.
WARNING
Compressed air used for cleaning purposes will not exceed 30 psi (207 kPa). Use
only with effective chip guarding and personal protective equipment, goggles,
shield, and gloves.
(5)
Dry pockets with compressed air.
(6)
Apply lubricating oil around area of ball pockets (1).
Change 3
7-97
