(1)
(2)
(3)
TM 9-2320-279-34-1
Transmission Maintenance Instructions (Cont)
7-4. TRANSMISSION REMOVAL/INSTALLATION (CONT).
b. Installation
NOTE
Refer to paragraph 23-9 if transmission
must be unpacked from container.
Install fittings, sending units, and plugs
from old transmission on new
transmission.
Skip steps (1) through (3) when
installing transmission on M984E1.
Uncover access hole before doing
step (1).
Install gasket (1) on transmission access
hole (2).
Install hydraulic pump (3) and PTO (4)
on transmission (5) with five nuts (6),
washers (7), and screw (8).
Tighten nuts (6) and screw (8) to 30 to 35 lb-ft (41 to 48 N•m).
WARNING
Adhesives, solvents, and sealing compounds can burn easily, can give off harmful
vapors, and are harmful to skin and clothing. To avoid injury or death, keep away
from open fire and use in well-ventilated area. If adhesive, solvent, or sealing
compound gets on skin or clothing, wash immediately with soap and water.
(3.1) Apply thread locking sealing compound to
threads of six screws (11).
NOTE
Left and right mounting brackets are installed
the same. Left side is shown.
(4)
Install transmission mount (9) with six
lockwashers (10) and screws (11). Tighten
screws to 130 to 140 lb-ft (176 to 190 N•m).
WARNING
Keep out from under heavy parts. Falling parts may
cause serious injury or death.
(5)
Hook one chain of lifting device to
transmission yoke (12) and chains to left
and right transmission mounts (9 and
13).
7-20
Change 3
