TM 9-2320-279-34-1
6-132 Change 5
Electrical System Maintenance Instructions (Cont)
6-18. HIGH MOUNT STOP LAMP HARNESS REMOVAL/INSTALLATION
(M978) (CONT).
(4)
Disconnect high mount stop lamp wire
harness connector (6) from chassis wire
harness connector (7) under left rear of
vehicle.
NOTE
·
Remove clamps, cushion clips, and
cable ties as necessary.
·
Cushion clips are returned to same
positions after section of high mount
stop lamp harness is removed.
·
Note routing of high mount stop lamp
harness to ensure proper installation.
(5)
Remove high mount stop lamp harness
(8) from vehicle.
b. Installation.
(1)
Position and route high mount stop lamp harness (1) as noted prior to removal.
NOTE
·
Install clamps, cushion clips, and cable ties as necessary.
·
Cushion clips are returned to same positions after section of high mount stop lamp
harness is installed.
(2)
Connect high mount stop lamp wire harness connector (2) to chassis wire harness connector (3)
under left rear of vehicle.
