TM 9-2320-279-20-3
Hydraulic System Maintenance Instructions (Cont)
(2) Remove cotter pin (2) and pin (3).
(3) Check that control lever (3) is full
forward to disengaged position. If so.
do step (8). If not. do steps (4) through
(8).
(4) Move control lever (4) full forward to
disengaged position.
(5) Loosen locknut (5).
(6) Adjust clevis (6) so holes in clevis
aline with hole in control lever (4).
(7) Tighten locknut (5).
(8) Install control lever (4) with pin (3)
and cotter pin (2).
d. Follow-on Maintenance.
(1) Recirculate fuel (TM 9-2320-279-10).
(2) Check that pump engages and
disengages when shift lever is moved.
(3) Close rear module doors
(TM 9-2320-279-10).
END OF TASK
Section IV.
HYDRAULIC LINES AND FLUID FILTER
19-16. HYDRAULIC LINES AND BRACKETS REMOVAL/INSTALLATION.
This task covers:
a. Typical Hydraulic Coupling Removal
b. Typical Hydraulic Coupling Installation
c. Typical Clip, Clamp, and Bracket Removal
INITIAL SETUP
Models
All
d. Typical Clip. Clamp, and Bracket Installation
e. Hydraulic Lines
f. Follow-on Maintenance
References
None
Test Equipment
Equipment Condition
None
Special Tools
None
Supplies
Tags, identification, Item 48, Appendix C
Ties, cable, plastic, Item 52, Appendix C
Personnel Required
MOS 63S, Heavy wheel vehicle mechanic
TM or Para
Condition Description
TM 9-2320-279-10 Shut off engine.
LO 9-2320-279-12
Hydraulic reservoir drained
(only when replacing
reservoir lines).
Special Environmental Conditions
None
General Safety Instructions
None
19-49
