TM 9-2320-279-20-2
Transfer Case and Propeller Shaft Maintenance Instructions (Cont)
9-10.
UNIVERSAL JOINT AND DUST CAP REMOVAL/INSTALLATION.
This task covers:
a. Removal
b. Installation
c. Follow-on Maintenance
INITIAL SETUP
Models
All
Test Equipment
None
Special Tools
None
Supplies
None
Personnel Required
MOS 63S, Heavy wheel vehicle mechanic
References
None
Equipment Condition
TM or Para
Condition Description
Para 9-9
Propeller shaft removed
from vehicle
Special Environmental Conditions
None
General Safety Instructions
None
a.
Removal.
NOTE
All universal joints are removed in the
same manner.
(1) Deleted.
(2)
Remove and discard two screws (3) from
each side of flange yoke (2).
CAUTION
Be careful when removing bearing caps or
needle bearings may fall out and be
damaged or lost.
(3)
Remove bearing caps (4) from each side
of flange yoke (2) and universal
joint (5).
(4)
Remove universal joint (5) from flange
yoke (2).
NOTE
Some universals may have two grease fittings.
(5)
Remove grease fitting (6) from universal joint (5).
(6)
Remove two grease seals (7) from universal joint (5).
9-26
Change 2
