TM 9-2320-279-20-2
Frame and Tire Carrier Maintenance Instructions (Cont)
14-8. REAR CROSSMEMBER BRACE REMOVAL/INSTALLATION.
This task covers:
a. Removal
b. Installation
c. Follow-on Maintenance
INITIAL SETUP
Models
References
All (except M984E1)
None
Test Equipment
Equipment Condition
None
TM or Para
Condition Description
Special Tools
TM 9-2320-279-10 Shut off engine.
None
Special Environmental Conditions
Supplies
None
None
General Safety Instructions
Personnel Required
None
MOS 63S, Heavy wheel vehicle mechanic
a. Removal.
(1)
(2)
NOTE
Both crossmember braces are
removed and installed the same
way. Left crossmember brace is
shown.
(1) Remove nut (l),
lockwasher (2), and
washer (3).
(2) Remove screw (4) and clip (5)
from crossmember brace (6).
(3) Remove four nuts (7),
screws (8), and crossmember
brace (6).
b. Installation.
Install crossmember brace (6)
with four screws (8) and
nuts (7).
Install screw (4), clip (5),
washer (3), lockwasher (2),
and nut (l).
c. Follow-on Maintenance.
None.
END OF TASK
14-16
