TM 9-2320-279-20-2
Brake and Air System Maintenance Instructions (Cont)
11-5.1
FRONT BRAKE CAMSHAFT AND AUTOMATIC SLACK ADJUSTER
REMOVAL/INSTALLATION (CONT).
(5)
(6)
(7)
(8)
(9)
(10)
(11)
NOTE
Shim washers are used to remove camshaft end play.
Adjust camshaft end play to within 0.005 to 0.025 in.
(0.127 to 0.635 mm) by adding or removing shim washers
as necessary.
Install shim washers (6) and retaining ring (7).
Position bracket (8) on brake chamber (9) with
washer (10) and nut (11). Do not tighten nut.
Rotate adjusting hex head (12) until slack adjuster (5)
hole alines with brake chamber yoke (13) hole.
Install bracket (8) on control arm (14) with nut (15). Do
not tighten nut.
Rotate control arm (14) away from adjusting
hex head (12), towards brake chamber (9),
until control arm comes to a definite
internal stop.
Tighten nut (15). Ensure that control
arm (14) does not move its position when
tightening nut.
Tighten nut (11).
11-12.4
Change 2
