Cleaning and Inspection. - TM-5-5420-234-14-P0989

TM-5-5420-234-14-P Truck Cargo 10-Ton 8x8 Common Bridge Transporter M1977 Without Winch Manual
Page Navigation
951

TM 5-5420-234-14&P

4-73. REMOTE CONTROL UNIT REPAIR (continued).

NOTE

Note position of circuit board prior to removal to ensure proper installation.

(19) Remove two screws (38) and circuit board (29) from base (5).

b. Cleaning and Inspection.

(1) Clean all parts. Refer to para 4-16.

(2) Inspect all parts. Refer to para 4-17.

(3) Replace all parts failing inspection.

c. Assembly.

NOTE

Install cable ties as required.

Make sure circuit board is installed in same position as noted during

disassembly.

(1) Install circuit board (29) in base (5) with two screws (38).

(2) Solder wires (37) on connector (35).

NOTE

Connector should be installed in base with notch facing up.

(3) Install new gasket (36) and connector (35) in base (5) with four screws (34), new lockwashers (33), and

nuts (32).

(4) Install four spade connectors (30) on relay (31).

(5) Install connector (28) on circuit board (29).

4--603

4 599

Privacy Statement
Press Release
Contact