TM 5-5420-234-14&P
4-12. UNIT TROUBLESHOOTING (continued).
19. BAP WINCH DOES NOT WIND IN (MODEL A ONLY) (continued).
CONTINUITY TEST
CAUTION
Electrical power must be shut
off from circuit before
continuity can be checked.
Failure to comply may result
in damage to test equipment
or electrical system.
(1) Remove connector from the WINCH
IN solenoid.
(2) Set multimeter to ohms position.
POSITION 2
NOTE
SOLENOID
A reading of infinity indicates an
CONNECTORTEST
open circuit.
POINTS
Junction box terminal "35" is
connected to one side of the
solenoid; terminal "36" is connected
to the other side.
(3) Connect multimeter leads to each
end of wire and check multimeter for
continuity. Check for continuity
between the solenoid connector,
position "1", and terminal strip,
position "35".
(4) Repeat Step 3 to check for continuity
POSITION 1
between position "2" in the connector
and terminal strip position "36".
WIRING REMOVED FOR CLARITY
4-4-14.5
4 411
Change 1
