TM 5-5420-234-14&P
4-12. UNIT TROUBLESHOOTING (continued).
18. BAP WINCH DOES NOT WIND OUT (MODEL A ONLY) (continued).
SOLENOID
CONNECTOR,
CONTINUITY TEST
POSITION 1
CAUTION
Electrical power must be shut
off from circuit before continuity
can be checked. Failure to
comply with this caution may
result in damage to test
equipment or electrical system.
(1) Remove connector from the winch out
solenoid.
(2) Set multimeter to ohms position.
SOLENOID
CONNECTOR,
NOTE
POSITION 2
A reading of infinity indicates an open
circuit.
Junction box terminal 33 is connected
to one side of the solenoid; terminal
34 is connected to the other side.
(3) Connect multimeter leads to each end
of wire and check multimeter for
continuity. Check for continuity
between the solenoid connector,
position 1, and terminal strip position,
33.
(4) Repeat Step 3 to check for continuity
between position 2 in the connector
and terminal strip, position 34.
WINCH OUT
SOLENOID HARNESS
WIRING REMOVED FOR CLARITY
Change 1
4-4-02.3
4 401
