TM 9-2320-279-34-3
Special Purpose Kit Installation Instructions (Cont)
23-2.
ARCTIC HEATER KIT INITIAL INSTALLATION (CONT).
(32)
While Soldier A holds skid plate grille (55) to skid plate (56), Soldier A removes 16 locknuts (57),
washers (58), and screws (59).
(33)
Soldier A and Soldier B remove skid plate grille (55).
NOTE
These two bolt holes will be used to mount bracket that supports coolant pump.
(34)
Remove and discard two nuts (60) and screws (61) from bottom of skid plate (56) nearest right
side of frame section (62).
(35)
Modify skid plate grille (55) as follows:
(a)
Cut a 17.0 in. (431.80 mm) by
18.50 in. (469.90 mm) opening in
skid plate grille (55).
(b)
Drill three 0.281 in. (7.14 mm)
holes in skid plate grille (55).
(c)
Break all sharp edges.
23-10
Change 3