TM 9-2320-279-34-2
Steering System Maintenance Instructions (Cont)
12-6. SLAVE STEERING GEAR AND PITMAN ARM REMOVAL/REPAIR/INSTALLATION (CONT).
CAUTION
When removing retaining pin, do not drill more than 1.625 in.
(41.27 mm) from top of output shaft gear teeth into retaining
pin or damage to output shaft will result.
(19) Remove roll pin (21) and drill out retaining pin (22) from
output shaft (7).
(20) Separate output shaft (7) and output shaft gear (23).
(21) Measure inside diameter of bearing (24). If bearing is more than 0.010 in. (0.25 mm) out of
round, do step (22).
(22) Remove bearing (24) from housing cover (10).
12-36