TM 9-2320-279-34-2
(11)
(11)
(12)
Steering System Maintenance Instructions (Cont)
Support backup washer (9).
Install dirt seal (11) in cylinder head (10) lip out, until seal
rests against backup washer (9). Apply grease to dirt seal.
Install salt seal (12) lip out, so it is flush with top of
cylinder head (10). Apply grease to salt seal.
(13) Install seal (13) evenly, garter spring up, until it rests
against backup washer (9). Apply grease to seal.
(14) Install actuating shaft assembly (14) in cylinder
head (10).
NOTE
If installing new nut, drill 3/32-in. (2.4 mm) hole for lock pin.
Use lock pin hole as guide when drilling.
(15) Install bearing retaining nut (15).
(16) Install lock pin (16).
12-27