Steering System Maintenance Instructions (Cont)
12-5. STEERING GEAR AND PITMAN ARM REMOVAL/REPAIR/lNSTALLATION (CONT).
Install bearing (3) into rear of housing cover (4)
(6.4 mm) below inside face of housing cover.
Coat inner surface of bearing (3) with grease.
(5) Aline arrow on output shaft (5) between
two punchmarks on gear (6).
(6) Install output shaft (5) in gear (6).
(7) Install retaining pin (7).
(8) Install roll pin (8).
about 1/4 in.
Backup washer must be properly seated to prevent oil
leakage when steering gear is pressurized. Oil leakage will
cause damage to equipment.
(9) Install backup washer (9) in large end of cylinder head