TM 9-2320-279-34-2
Steering System Maintenance Instructions (Cont)
12-5. STEERING GEAR AND PITMAN ARM REMOVAL/REPAIR/iNSTALLATION (CONT).
NOTE
Seals and backup washer can be removed by pressing all
three seals toward inside of cylinder head.
(20) Remove seal (27), backup washer (28), dirt seal (29), and
salt seal (30) from cylinder head (5).
CAUTION
Do not drill more than 1.625 in. (41.27 mm) from top of
output shaft gear teeth into retaining pin or damage to
output shaft will result.
(21) Remove roll pin (31) and drill out retaining pin (32).
(22) Separate output shaft (6) and output shaft gear (33).
12-24