TM 9-2320-279-34-1
Axles No. 1 and No. 2 Maintenance Instructions (Cont)
9-13. BALL SOCKET REMOVAL/INSTALLATION (CONT).
(18) Install end plate (22) and two screws (23) on upper axle
ball trunnion (12). Tighten screws to 40 lb-ft (54 N·m).
NOTE
Steps (19) through (25) are
for left ball socket only.
Install same number and
thickness of shims as
removed.
(19) Install shims (24) on four
studs (6).
NOTE
Install steering arm with
flange side down.
(20) Install steering arm (25) on
studs (6).
(21) Install four dowel pins (26)
in studs (6).
(22)
(23)
(24)
(25)
Secure steering arm (25) with
four lockwashers (27) and
nuts (28).
Tighten nuts (28) to 35 to 40 lb-ft
(47 to 54 N·m).
Install grease fitting (29).
Lubricate upper bearing at
grease fitting (29).
9-90