TM 9-2320-279-34-1
Transmission Maintenance Instructions (Cont)
7-18. THIRD CLUTCH AND CENTER SUPPORT HOUSING REMOVAL/REPAlR/lNSTALLATlON
(CONT).
e . I n s t a l l a t i o n .
(1) Install third clutch piston (1) in center support housing (2).
(2) Install thrust washer (3).
NOTE
Center support housing is fitted to
transmission housing with very little
clearance and may bind if transmission
housing is cold. Heat transmission housing
with heat lamp or warm current of air.
(3) Lower center support housing (2) in
transmission housing (4). Make sure
tapped hole (5) in support housing is
alined with screw hole (6) in
transmission housing.
(4) Install support housing anchor screw (7)
and washer (8). Tighten support housing
anchor screw finger-tight.
7-128