Transmission Maintenance Instructions (Cont)
Soldier A alines two pitot tube guide
screws with two small holes in torque
converter housing (11) while Soldier B
operates lifting device.
Take care not to damage pitot tube and
collector ring when installing converter
Install torque converter housing (11)
on transmission housing (12).
Remove lifting device and lifting eyes.
Move pitot tube guide screws up and down to
check that pitot tube is free.
Install seven screws (13) and
lockwashers (14). Tighten screws to 67
to 80 lb-ft (90 to 108 Nm).
Adhesives, solvents, and sealing compounds
can burn easily, can give off harmful vapors,
and are harmful to skin and clothing. To
avoid injury or death, keep away from open
fire and use in well-ventilated area. If
adhesive, solvent, or sealing compound gets
on skin or clothing, wash immediately with
soap and water.
Apply small amount of silicone
adhesive-sealant to two screws (15) and
Remove one pitot tube guide screw and
install screw (15) and washer (16).
Remove other pitot tube guide screw
and install screw (15) and washer (16).
Tighten screws (15) to 30 to 48 lb-in.
(266 to 425 Nm).