TM 9-2320-279-34-1
Transmission Maintenance Instructions (Cont)
(5)
(6)
(7)
(8)
(9)
(10)
Install roller bearing (6) on roller race (7).
Install roller race (7) in stator (1) until roller bearing (6) is near stator roller holder.
Remove stator roller holder by pulling on attached string.
Push roller race (7) inward while turning roller race clockwise until roller bearing (6) seats.
Position stator (1) with roller race (7) up.
Turn roller race (7) counterclockwise to lock in place.
e . I n s t a l l a t i o n .
CAUTION
Keep outer face of stator down so bearings and springs
will not fall out.
(1) Hold stator (1) with thrust pads (2) away from
transmission (3).
CAUTION
Stator must turn freely in clockwise direction and lock up
in counterclockwise direction to operate properly and
prevent damage to equipment.
(2) Install stator (1) on shaft (4).
f. Follow-on Maintenance. Install flywheel assembly (para 7-6).
END OF TASK
7-49