Transmission Maintenance Instructions (Cont)
N O T E
Left and right side mounting
brackets are removed the same.
Left side is shown.
Tag and mark mounting brackets.
(59) Remove six screws (122),
lockwashers (123), and transmission
Skip steps (61) through (64) for M984E1.
(60) Remove five nuts (124) and washers (125) from base of FY10 (126).
(61) Remove screw (127).
(62) Remove PTO (126) and hydraulic pump (128) from transmission (120).
Access hole must be covered to prevent dust and dirt from entering transmission
and causing damage to equipment.
(63) Remove gasket (129) from transmission (120). Cover transmission access hole (130).
All components removed in this procedure must be installed on replacement (new)
Refer to paragraph 23-9 if transmission is to be prepared for storage.