TM 9-2320-279-34-1
Change 5
6-14.3
Electrical System Maintenance Instructions (Cont)
(16)
Remove three locknuts (35), washers
(36), and screws (37) from drive end
housing (38) and slip ring end housing
(25).
CAUTION
When removing rotor, completely separate
rotor from stator. Stator will still be attached
to slip ring housing. Do not attempt to
separate stator from slip ring housing. Failure
to comply may result in damage to stator
wires.
NOTE
Rotor will remain attached to drive end
housing during removal.
(17)
Remove drive end housing (38) and
rotor assembly (39) from slip ring end
housing (25) and stator (40).
(18)
Remove three nuts (41) and stator (40)
from slip ring end housing (25).
(19) Remove two screws (42) and capacitor
(43) from positive rectifier (44) and
negative rectifier (45).
(20)
Remove screw (46) and wire (47) from
positive rectifier (44).
(21)
Remove nut (48) and positive terminal
screw (49) from positive rectifier (44)
and slip ring end housing (25).