Cab and Body Maintenance Instructions (Cont)
Drycleaning Solvent (P-D-680) is TOXIC and flammable. Wear protective goggles,
face shield, and gloves; use only in a well-ventilated area; avoid contact with skin,
eyes, and clothes, and do not breathe vapors. Keep away from heat or flame. Never
smoke when using solvent; the flashpoint for Type I Drycleaning Solvent is 100_F
(38_C) and for Type II is 140_F (60_C). Failure to do so may result in injury or
death to personnel.
If personnel become dizzy while using cleaning solvent, immediately get fresh air
and medical help. If solvent contacts skin or clothes, flush with cold water. If
solvent contacts eyes, immediately flush eyes with water and get immediate medical
(1) Clean metal surfaces with drycleaning solvent.
Check for cracked or broken parts and frayed or torn webbing.
Replace all damaged parts.
Procedure is identical for both seats. Left seat is shown.
Position D-ring (1) in cab assembly (2) with two hardened washers (3), comfort latch (4),
spacer (5), washer (6), locknut (7), and screw (8).
Tighten locknut (7) to 70 to 75 lb-in (8 NSm).
(2.1) Install cap (8.1) on screw (8).
Install retractor unit (9) to cab assembly (2) with washer (10), screw (11), L-bracket (12) and
Tighten locknut (13) to 70 to 75 lb-in (8 NSm).