5-19. WINCH HYDRAULIC TUBE (COMPRESSION FRAME) REPLACEMENT.
This task covers:
Tools and Special Tools
Tool Kit, General Mechanic's: Automotive
Engine turned off (TM 9-2320-279-10)
Wheels chocked (TM 9-2320-279-10)
Wrench, Combination, 1-1/8 in. (1172)
Special Environmental Conditions
Cleanliness is extremely important when working
on hydraulic equipment. Clean all parts before
Tags, Identification (as required) (Item 23,
disassembly and work in a clean work area.
The LHS hydraulic system operates at oil pressures up to 3625 psi (24,994 kPa).
Never disconnect any hydraulic line or fitting without first dropping pressure to zero.
Failure to comply may result in serious injury to personnel.
Tag and mark all hoses and tubes
prior to removal.
Cut cable ties as required.
Left and right side procedures are
the same. Left side is shown.
Cap and plug all hoses and tube
(1) Remove hose (1) from union (2) at front of
compression frame (3).
(2) Remove union (2) from tube (4).