TM 5-5420-234-14&P
4-12. UNIT TROUBLESHOOTING (continued).
14. MAIN FRAME DOES NOT UNLOAD IN MANUAL MODE (MODEL A ONLY)
(continued).
VOLTAGE TEST
(1) Turn engine start switch to ON
position.
(2) Turn light control switch to STOP
LIGHT position.
(3) Rotate LHS MODE SELECT switch
to position 3 (main frame in manual
mode).
MAIN FRAME
UNLOAD (YELLOW)
CAUTION
When checking voltage, use cau-
tion not to short or ground the
terminal being checked. Fail-
ure to comply with this caution
may result in damage to vehicle
or test equipment.
NOTE
Refer to illustration for correct wire.
(5) Place positive (+) probe of
multimeter on yellow (UNLOAD)
wire on LHS MODE SELECT
switch.
(6) Place negative (-) probe of
MAIN FRAME
LOAD (YELLOW)
NOTE
This test can also be accomplished
by observing the status of LED D8
while performing Step 7.
(7) Hold joystick in UNLOAD position
and check multimeter for voltage
reading.
(8) Turn engine start switch and light
control switch to OFF position.
Change 1
4-289