In case of emergency while the remote
control unit is in use, push the emergency
stop switch to shut down operation of the
a. Make sure
launch conditions comply with paragraph
Back up Transporter to within 15 feet of water, apply
parking brake, and place transmission in neutral.
Connect two winch pressure lines (1) to male
connector and female connector (2) located on bottom
of hook arm assembly.
When selecting PTO ENGAGE switch, engine must be at low idle speed. Se-
lection of PTO ENGAGE switch with HIGH IDLE switch on may result in
sudden application of hydraulic pressure to the LHS, resulting in damage to
PTO ENGAGE switch must be turned off before road transport or severe
equipment damage could result.
d. Turn LHS MODE SELECT switch (3) to AUTO, and turn PTO ENGAGE switch (4) to ON.