2-14. CONTROLLED BRIDGE BAY LAUNCH (continued).
Position WINCH switch (20) to IN and release when cable slack is removed.
After releasing rear guides, only the winch hook secures bridge bay to the BAP.
Personnel must not mount the BAP and must stay clear of the area around rear of
Transporter. The load could shift, release, or fall, resulting in death or injury to
k. Set curb-side and road-side rear guides (22) to fully open
Rotate latch pin (21) until rear guide (22) disengages.
Swing rear guide (22) until latch pin (21) engages in rear
of bay guide (23).