2-14. CONTROLLED BRIDGE BAY LAUNCH (continued).
Make sure appropriate bridge bay latches are hooked or death or injury to
personnel could result.
Interior bay has four foldlock latches, two at each end; ramp bay has two
foldlock latches at one end only.
Interior bay has two travel latches, one at each end; ramp bay has one travel
latch at one end only.
h. Interior bay: release front and rear foldlock latches (14) and travel latch (15) at rear of bridge bay (16).
Ramp bay: release two foldlock latches (14) at front of bridge bay (16).
If BAP front pin lock assemblies cannot
be unlocked, use remote controls to
maneuver LHS hook arm to move the load
slightly to free the lock. Failure to free the
lock will result in damage to equipment.
Release curb-side and road-side BAP front pin lock
Pull front pin lock assembly (17) out while pushing latch
lever pin (18) down until it rests at top of vertical slot (19).