e. When refilling No. 2 and No. 3 differentials,
add 1 Qt (0.94 L) of lubricant through fill hole in top
b. During lubricant changes on the No. 2 and
of power divider.
No. 3 axles, clean the lube pump filter screen. To
7. OILCAN POINTS. Every 1,000 mi (1 600 km)
completely drain No. 2 and No. 3 axles, remove
or monthly; lubricate doors, side panels and en-
plug at bottom of power divider in addition to drain
gine cover hinges, locks, and latches.
plug in bottom of differential housing.
c. Fill No. 1 and No. 2 differential housings to a
Copy of this lubrication order will remain with the
level even with bottom of CHECK and FILL plug
equipment at all times; instructions contained here-
in are mandatory.
d. When filling No. 3 and No. 4 differentials, fill to
By Order of the Secretary of the Army:
bottom of CHECK and FILL hole, then raise one
end of axle 8 in. (203 mm) to allow lubricant to flow
out to wheel bearing. Lower the axle and refill.
Raise other end of axle the same way, then lower
DENNIS J. REIMER
General, United States Army
and refill again.
Chief of Staff
JOEL B. HUDSON
Administrative Assistant to the
Secretary of the Army
To be distributed in accordance with the Initial
Distribution Number (IDN) 380553, requirements
for LO 9-2320-279- 12.
CARD 35 OF 35
*U.S. GOVERNMENT PRINTING OFFICE:1999-454-099/80010